Yamaha HTR-6180 - Manual (Page 126)

RESETTING THE SYSTEM
122
En
Use this feature to reset all the parameters of this unit to the initial factory settings.
• This procedure completely resets all the parameters of this unit including the “SET MENU” parameters.
• The initial factory settings are activated next time you turn on this unit.
y
To cancel the initialization procedure at any time without making any changes, press LSYSTEM OFF on the front panel.
1
Press L
SYSTEM OFF on the front panel to
set this unit to the standby mode.
2
Press and hold M
TONE CONTROL and
then press K
MAIN ZONE ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Rotate the N
PROGRAM selector to select
“INIT”.
4
Press M
TONE CONTROL repeatedly to
select “ALL”.
y
Select “CANCEL” to cancel the initialization procedure
without making any changes.
5
Press L
SYSTEM OFF to confirm your
selection and set this unit to the standby
mode.
Resetting the system
Notes
TONE CONTROL
ON/OFF
MAIN ZONE
While holding
down