Yamaha HTR-6180 - Manual (Page 60)

56
En
FM/AM tuning
3
Press E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to select a
preset station group and number (A1 to E8)
while the MEMORY indicator is flashing.
• Press Eh (or 8k) to select a higher preset
station group and number.
• Press El (or 8n) to select a lower preset station
group and number.
y
You can select the preset station group (A to E) by pressing
DA/B/C/D/E (or 8A-E/CAT. l / h) repeatedly.
4
Press F
MEMORY (or 9MEMORY) while
the MEMORY indicator is flashing.
The station band and frequency appear in the front
panel display with the preset station group and
number you have selected. The MEMORY indicator
disappears from the front panel display.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset
station number.
• The reception mode (stereo or monaural) is stored along with
the station frequency.
■ Exchanging preset stations
You can exchange the assignments of two preset stations
with each other. The example below describes the
procedure to exchange preset station “E1” with “A5”.
1
Select preset station “E1” using D
A/B/C/D/E
and E
PRESET/TUNING/CH l / h.
See “Using station preset feature” on page 54.
2
Press and hold B
EDIT for more than 3
seconds.
“E1” and the MEMORY indicator flash in the front
panel display.
3
Select preset station “A5” using D
A/B/C/D/E
and E
PRESET/TUNING/CH l / h.
“A5” and the MEMORY indicator flash in the front
panel display.
See “Using station preset feature” on page 54.
4
Press B
EDIT again.
“EXCHANGE E1-A5” appears in the front panel
display and the assignments of the two preset stations
are exchanged.
Notes
MEMORY
A1:FM 88.9MHz
The displayed station has been stored as A1.
Flashes
Before performing the following operations, set the operation
mode selector on the remote control to FSOURCE and then
press 4TUNER.
MEMORY
E1:FM 88.9MHz
Flashes
Flashes
MEMORY
A5:FM 88.9MHz
Flashes
Flashes