Yamaha DGX-305 - Manual (Page 94)

Keyboard Stand Assembly (DGX-505 Only)
94
DGX-505/305 Owner’s Manual
x
Attach the back board.
Attach the back board, using the 6 x 30 mm round head
screws
e.
There is no particular vertical or left-to-right orientation
for the back board, and it can be installed either way.
• Be careful not to drop the back board or touch the sharp metal fit-
tings.
c
Put the keyboard on the stand.
Carefully place the keyboard on the side boards.
There is no back-to-front orientation for the stand, and
the keyboard can be placed on it facing either direction.
Slowly move the keyboard so that the holes on the bottom
of the keyboard are properly aligned with the holes on the
angle brackets.
• Be careful not to drop the keyboard or to get your fingers caught
between the keyboard and the stand parts.
v
Install the keyboard to the stand.
Fix the keyboard to the angle brackets, using the 5 x 16
mm round head screws
r.
2
e 6 x 30 mm round head screws
3
4
r
5 x 16 mm round
head screws
■ Post-assembly checklist
Once you’ve assembled the stand, check the following points:
• Are there any parts left over?
➔ If so, read the assembly instructions again and correct any
errors you might have made.
• Is the instrument clear of doors and other movable fixtures?
➔ If not, move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you play it or
move it?
➔ If so, properly tighten all screws.
• Also, if the keyboard makes a creaking noise or seems
unsteady when you play it, refer carefully to the assembly
instructions and diagrams and retighten all screws.
CAUTION
CAUTION