Xerox 4151 User Manual
Page 20
Getting Started
12
1
Connecting the Machine to the Host Using the Parallel Interface
Cable
Connect the machine to the host computer using a parallel interface cable com-
pliant with IEEE 1284 (supplied by you).
Follow these steps to connect the machine to the host computer.
AAAA
Confirm that you have the correct cable.
BBBB
Confirm that both the machine and the host computer are turned off.
CCCC
Plug the 36-pin end of the parallel cable into the parallel port at the right
side of the back cover of the machine.
Reference
See p.8 “Connecting the Machine” to confirm the position of the parallel
port.
DDDD
Squeeze the wire clips on each side of the connector together until they
snap into place. The clips hold the cable securely in place.
EEEE
Plug the other end of the parallel cable into the computer's parallel port.
KirC-P1DXP-GB_F_FM.book Page 12 Friday, February 8, 2002 2:13 PM