Xerox 4151 - Manual (Page 18)

Getting Started
10
1
Connecting the Network Interface Cable to the Network
Connect the machine to the network using optional Network Interface Board
Type 1018.
Follow these steps to connect the machine.
AAAA
Confirm that you have the correct cable.
BBBB
Confirm that the machine is turned off.
CCCC
Loop the network cable. The loop should be about 15cm (6”) from the end
of the cable on the end closest to the printer.
DDDD
Attach the ferrite core to the loop.
EEEE
Attach the network cable to the 10BASE-T/100BASE-TX port on the ma-
chine.
Reference
See p.8 “Connecting the Machine” to confirm the position of the 10BASE-
T/100BASE-TX port.
Note
❒ Confirm that the cable is connected to the 10BASE-T/100BASE-TX port.
FFFF
Connect the other end of the cable to the network.
KirC-P1DXP-GB_F_FM.book Page 10 Friday, February 8, 2002 2:13 PM