beautypg.com

2 dma usage, Dma usage – ZyXEL Communications DMA-1000 Series User Manual

Page 74

background image

Chapter 11 Troubleshooting

DMA-1000 Series User’s Guide

74

11.2 DMA Usage

V

I cannot see the DMA menus on the television screen.

1 Check the hardware connections, and make sure the LEDs are behaving as expected. See

the Quick Start Guide and

Section 11.1 on page 73

.

2 Make sure your Internet browser does not block pop-up windows and has JavaScripts

and Java enabled. See

Section 11.1 on page 73

.

3 Make sure your television is set to display the DMA’s input. If you used an HDMI

connection between the television and the DMA, make sure the television input is set to
HDMI. If you used a S-Video connection between the television and the DMA, make
sure the television input is set to S-Video.

4 Turn the DMA off and on using the power switch on the rear panel (instead of the Power

button on the remote control).

5 If the problem continues, contact the vendor.

V

I cannot see or access the media server folders on the television screen.

1 If the server icon in the bottom right of the screen has a 0, try turning the DMA off and

on using the power switch on the rear panel (instead of the Power button on the remote
control).

2 Check the hardware connections, and make sure the LEDs are behaving as expected. See

the Quick Start Guide and

Section 11.1 on page 73

.

3 Make sure the media server computer is on and has an IP address in the same subnet as

the DMA. (If you know that there are routers between your computer and the DMA, skip
this step.)

4 Check the media server program’s Published Folder and Security settings. If you have

to change these settings, turn the DMA off and on again afterwards.

5 Check the security settings of any software firewalls on the media server computer.

Make sure that any software firewalls on the media server computer are configured to
allow the DMA to access the media server. See the

The DMA cannot access the media

server.

If you have to change any firewall settings, turn the DMA off and on again

afterwards.

V

The DMA cannot access the media server.

Make sure that any software firewalls on the media server computers are configured to allow
the DMA to access the media server.