Zebra Technologies XiIII - Manual (Page 88)

CANCEL Key Self Test
This self test prints a listing of the
configuration parameters currently
stored in the printer’s memory. See
Figure 33 (depending on the options
ordered, your label may look
different).
1. Turn the printer off.
2. Press and hold the CANCEL key
while turning on the power.
The configuration may be changed
either temporarily (for specific label
formats or ribbon and label stock) or
permanently (by saving the new
parameters in memory). Saving new
parameters occurs whenever a
calibration procedure is performed.
Refer to page 15 for further
information about the
configuration
procedure .
82 Zebra XiIII-Series User’s Guide
Figure 33