Zebra Technologies XiIII - Manual (Page 78)

Adjustments
Toggle Positioning
Both toggles should be positioned so that they provide even pressure on the
media. The toggles are positioned by sliding them to the desired location.
On media too narrow to accommodate both toggles, or if you are using a
90 or 96
XiIII printer, position one toggle over the center of the media and
decrease the pressure on the unused toggle.
NOTE: Make sure that the toggle pressure is even across the width of the
media. Otherwise, the media and/or ribbon may “drift.”
72 Zebra XiIII-Series User’s Guide
Adjusting
nuts
Label
available
sensors
Figure 32