Cutter mode 32, Cutter mode – Zebra Technologies XiIII User Manual

Page 38

Cutter Mode

NOTE: Cutter option required.

Refer to

1. Open the printhead.

2. Slide the media guide and media supply guide as far from the printer

frame as possible. Flip down the media supply guide.

3. Load media as shown.

4. Flip up the media supply guide. Slide in the media guide and media

supply guide so they just touch, but not restrict, the edge of the roll.

5. Close the printhead.

6. The printer will automatically feed out and cut one label when the

printer is turned on.

32 Zebra XiIII-Series User’s Guide