Xantrex Technology C40R/50 Remote - Manual (Page 19)

975-0123-01-01 Rev A 13
Figure 7 Connecting the Remote
RJ-15
Port
Remote (back)
2
4
5
6
3
Plug the SCC into the RJ-15 Port on
the circuit board of the controller.
Route one end of SCC through
strain relief on controller.
Route the other end of the
SCC to the RJ-15 Port on
the back of the Remote.
Serial Communications Cable
(SCC)
Align the original
faceplate and replace
the 4 screws.
Mount the display
up to 1,000 ft from
the controller.
Remove these
4 screws to
access circuit
board. 1