4 installation, Installation, 4 installation – Xantrex Technology C40R/50 Remote User Manual

Page 13

975-0123-01-01 Rev A

4 Installation

The following sections describe how to install the

C-Series Meter

Display

. They include detailed instructions for the following steps.

1. Jumper Installation (Step 1): Set the voltage setting on the

faceplate or remote to match the system voltage by installing the

jumper over the appropriate pins. This step is critical to the proper

operation of the unit.
See

for instructions.

2. Cable Installation (Step 2): Connect the display to the C-Series

controller using the communications cable.
See

for instructions.

3. Faceplate/Remote Installation (Step 3): Determine the location

and mounting method for the remote (if used).
See

for instructions.

Important:

The green and red color of the LED only indicates the

particular operating mode and the battery voltage level. It does not
indicate whether the charging source is functioning properly.

This manual is related to the following products: