Spectrum display – Yamaha DME64N User Manual

Page 41

anel Operation and Displa

Spectrum Display

DME64N/DME24N Owner’s Manual

Select the desired monitor point from the list.

The audio signal from the selected monitoring point will
be output via the PHONES jack and the [MONITOR]
indicator lights up.

Probe Monitor Functions

The Probe Monitor function allows monitoring points to
be selected from the DME Designer application. For
details, see the “DME Designer Owner’s Manual.”
When the Probe Monitor function is used the monitoring
point will change and the [MONITOR] indicator will
flash.

Spectrum Display

The monitor functions also provide spectrum analyzer type
level display of the signal at the selected monitor point.

Procedure

Select the monitor point for which you want to
see a spectrum display from the list.

Press the [ENTER] key.

A spectrum display of the audio signal at the selected
monitor point will appear.

1 Frequency
These are the separate frequency bands displayed.

2 Band Output Level
Signal level is displayed independently in 31 separate
frequency bands. Output level is displayed in 12 steps.

3 Peak Hold
When the peak hold function is ON, peak levels since the
current monitor point was selected are held indefinitely.
Peak levels are cleared after one second when peak hold is
OFF.
To turn the peak hold function ON or OFF, move the
cursor to the PEAK HOLD ON/OFF setting and press the
[ENTER] key to alternately turn it ON or OFF.

NOTE

Press the [CANCEL] key to move back to the previous edit
display.

NOTE

When the monitoring function is set to ON
([MONITOR] indicator lit steadily), you can turn it OFF
by pressing the [MONITOR] button.

NOTE

The monitoring point selected in the DME64N/24N is disabled.

NOTE