Yamaha DME64N - Manual (Page 26)

A
udio I/O Connection
DME64N/DME24N Owner’s Manual 26
Analog Audio Connection ([IN] and [OUT] Connectors) (DME24N only)
The DME24N includes [IN] and [OUT] connectors for 8 channels of analog audio input and output. Wire
the supplied Euroblock plugs as shown below. Head amplifier gain and phantom power settings can be made
via the Utility display HA page described on page 54 of this manual, or via the DME Designer application.
Euroblock Connection
1.
Prepare cables to be attached to a Euroblock plug as shown below.
Be sure to use shielded cable.
Do not tin (plate with solder) the exposed sections of the cable.
2.
Loosen terminal screws.
3.
Insert cables.
4.
Securely tighten terminal screws.
Pull the cables (not too strongly) to confirm that they are securely connected.
Audio I/O Connection
NOTE
A slotted screwdriver with a blade width of about 3 millimeters is recommended.
3mm
7mm
30mm
Shielded Cable
CAUTION
WARNING
Loosen.
Euroblock Plug
Slotted Screwdriver
Terminal Screw