Yamaha Pocket Recorder - Manual (Page 74)

Appendix
POCKETRAK CX Reference Manual
74
Troubleshooting
The unit does not operate.
Possible cause Battery is not inserted properly or is exhausted.
Corrective action
Reinsert the battery correctly.
Recharge the eneloop or replace with a new alkaline battery (see
page 71 ).
Buttons do not work.
Possible cause The Hold function is set.
Corrective action
Set the [HOLD/CHARGE] switch (located on the rear panel of the unit) to
its original position to cancel the Hold function.
Possible cause The USB terminal is still connected to the computer.
Corrective action Disconnect the unit from the computer (see page 55 ).
The eneloop cannot be recharged from the connected computer.
Possible cause The BATTERY SET is set to “ALKALINE.”
Corrective action Set the BATTERY SET to “eneloop” (see page 51 ).
Possible cause The [HOLD/CHARGE] switch is not set correctly.
Corrective action Set the [HOLD/CHARGE] switch to [HOLD w ].
Icon " “ appeared when you attempted to recharge the battery.
Possible cause
• You attempted to recharge a battery other than the eneloop.
• You attempted to recharge the battery, but no battery was inserted.
• The eneloop is not inserted correctly.
Corrective action Insert the eneloop battery into the unit.
Possible cause The unit is overheated.
Corrective action
Disconnect the unit from the PC, let the unit cool down for a while, then
try to recharge again.
The unit does not recognize the inserted microSD card.
Possible cause The microSD card is not inserted correctly.
Corrective action Turn off the power to the unit, then insert the microSD card correctly.
Possible cause
The microSD card was formatted on a computer or device other than the
recorder.
Corrective action Use the POCKETRAK CX to format the microSD card (see page 46 ).