Yamaha Pocket Recorder User Manual
Page 49
Using the Timer Functions
POCKETRAK CX Reference Manual
49
3.
Specify the alarm time ([ALARM TIME]).
Press the [
]/[
] buttons to select the hour or
minute, use the [VOL +/-] buttons to set the value,
then press the [MENU/ENTER] button.
4.
Press the [VOL +/-] buttons to select [BEEP] or
[MUSIC] as the alarm sound, then press the
[MENU/ENTER] button.
Note:
· If you wish to use your favorite song as the alarm instead of a beep, first connect the
recorder to a computer, then place your favorite MP3 or WMA music file in the ALARM
folder (see
). Then select [MUSIC]. If there is no file in the ALARM folder, a beep
will sound instead of music. Make sure that the recorder’s volume level is set appropri-
ately. If the volume level is set to “0,” you will not hear the alarm at the programmed
time.
5.
Press the [STOP/ESC
] button twice.
The alarm is now programmed.
At the programmed time, the alarm will go off. If you selected “BEEP,” a beep will
sound for about 10 seconds. If you selected “MUSIC,” the music file (the entire
song) in the ALARM folder will be played back.
Note:
· The alarm indicator (
) will flash while the alarm is sounding.
· Press the [STOP/ESC
] button to stop the alarm.
· You can program the time up to 24 hours ahead.
· The alarm will be cancelled once the programmed alarm has sounded.
· You cannot program Timer recording if the alarm has already been programmed, and
vice versa.
■
Canceling the alarm
Select [CANCEL] in step 2 of the “Programming the
alarm” procedure, then press the [MENU/ENTER] button.
The alarm indicator (
) disappears.
[BEEP]
Beep sound
[MUSIC]
A music file in the ALARM folder will be played.