Yamaha NOT FOND DSP-Z11 - Manual (Page 45)

Optimizing the speaker setting for your listening room (YPAO)
45
En
Prepara
tion
8
Once all measurement items are set successfully,
following display appears in the menu screen.
In this menu, you can perform the following operations:
• Press 9n and select “Setup” to set the measured values.
• Press 9k and select “Retry” to retry the automatic setup
procedure. This unit starts the automatic setup procedure
immediately again.
• Press 9h and select “Detail” to view information about
measurement results and warning messages. In the
information display, press 9k / n repeatedly to toggle
between the parameters. See page 46 for details.
• Press 9l to cancel the measurement results and exit from
the automatic setup menu.
9
Press I
MENU to turn off the GUI menu.
• After you have completed the automatic setup procedure, be sure to
disconnect the optimizer microphone.
• The optimizer microphone is sensitive to heat. Keep it away from direct
sunlight and do not place it on top of this unit.
■ Reviewing the result of the automatic setup
Use this feature to review the result of the automatic setup.
1
Set the operation mode selector to F
AMP and then
press I
MENU to turn on the GUI screen.
2
Press 9k / n repeatedly and then 9h to select
“Auto Setup”.
3
Press 9k to select “Information”.
4
Press 9h and then 9k / n repeatedly to select the
desired check items.
If error or warning messages appear...
When this unit detects potential problems during the
automatic setup procedure, error or warning messages
appears in the result display. See the “Auto Setup” section
in “Troubleshooting” on page 126 for a complete list of
error or warning messages and proper remedies.
Press 9l to view the detailed information of the error or
warning messages.
Notes
Angle Check
Angle
Result
Retry
Exit Detail
Setup
Measurement Over
Successfully
Angle Check
Angle
Result
Retry
Exit Detail
Setup
Measurement Over
W1:Out of Phase
W3:Level Error
Error or warning messages Error or warning messages
Input Select
Manual Setup
Auto Setup
System Memory
Signal Info.
Information
Setup Menu
Start
Information
Setup Menu
Start
Multi Measure
Wiring
Distance
Multi Measure
Wiring
Distance
Size
Left Right
Front NRM NRM
Center NRM
Sur. NRM NRM
S.Back NRM NRM
F.PRNS NRM NRM
R.PRNS NRM NRM
SubWfr DET
DET
Reload:ENTER