Zoom G7.1ut User Manual

Page 10

ZOOM G7.1ut

ÉBpmTp

BpmTp é

NewDrive

NewDrive ™LVL100

LVL100

"E" symbol

If the currently displayed
setting value differs from
the original patch setting,
the indication "E" (for
"Edited") appears.

BANK [

W] foot switch LED

This is always lit when the G7.1ut is in manual mode. When you press this
foot switch in manual mode, the unit returns to play mode.

Patch level

Shows the output
level of the currently
selected patch.

Shows the number of the
parameter knob that controls
the patch level.

[PRE-AMP A/B] keys

The key for the channel (A or B) that is
currently selected for the pre-amp section is lit.

Function foot switch
assignment

Effect module keys

Keys for modules that are active in the
currently selected patch are lit in red.

Foot switch 1 - 4 LEDs
When the module for the respective foot switch is on, the respective LED is lit.

Shows the function
assigned to the function
foot switch (

→ p. 34).

Switching Modules On and Off With Your Foot During Play

(Manual Mode)

The condition where foot switches 1 – 4 are used to switch the major modules in a patch on and off
individually is called "manual mode". In this mode, the single effects of the G7.1ut can be controlled with
your foot like independent compact effects.

In play mode, select a patch.

Press and hold the BANK [

W] foot

switch for at least 1 second.

The LED of the BANK [

W] foot switch lights up

and the G7.1ut switches to manual mode.

In manual mode, the following information
appears on the panel (see illustration below).

NOTE

In manual mode, you cannot use the foot switches
to select patches. However, the [TYPE] knob
(group/bank selection) and the parameter knob 1
(patch selection) operate in the same way as in
play mode. Please note that you go back to "play
mode" when you change patches.

To switch a module between on and
off, press the foot switch for that

Hold down for 1 second
or more

Switching Modules On and Off With Your Foot During Play (Manual Mode)

ZOOM G7.1ut

module.

In manual mode, you can use foot switches 1 – 4
to switch the major effect modules on or off. The
module/switch allocation is as follows.

HINT

• When a module is switched on/off, the [STORE/

SWAP] key lights up.

• In manual mode, you can use the knobs on the

panel as in play mode to adjust pre-amp
parameters, patch level, and the tube energizer.
For an explanation of operation procedures, see
"Adjusting the sound" in the section on play
mode (

→

p. 15).

• From manual mode you can switch to edit mode

for editing patches. For details on edit mode,
see page 23.

To return to play mode, press the
BANK [

W] foot switch.

NOTE

The changes that you have made to a patch will be
lost when you select another patch. To keep the
changes, store the patch first (

→

p. 27).

Foot switch 1

WAH/EFX1
module

Foot switch 3

MOD/EFX2
module

Foot switch 2

PRE-AMP
module

Foot switch 4

DELAY
module