Zebra Technologies R110Xi - Manual (Page 60)

48 R110Xi/R170Xi User Guide 23063L-003 Rev. 1 12/6/04
Front Panel Controls
Front Panel LCD
LIST IMAGES List Images
• Press the right oval to print a label that lists the available images stored in the
printer’s RAM, Flash memory, optional EPROM, or optional memory card.
LIST FORMATS List Formats
• Press the right oval to print a label that lists the available formats stored in the
printer’s RAM, Flash memory, optional EPROM, or optional memory card.
LIST SETUP List Setup
• Press the right oval to print a label that lists the current printer configuration.
(Same label as shown in Print a Printer Configuration Label on page 32 .)
LIST NETWORK List Network Settings
This selection is used to print a network configuration label, which lists the settings
for the wired ZebraNet PrintServer II (PSII) and the ZebraNet Wireless Print Server
(if installed).
• Press the right oval to print a label that lists the current network configuration.
(Same label as shown in Print a Network Configuration Label on page 34 .)
LIST ALL List All
• Press the right oval to print labels that list the available fonts, bar codes, images,
formats, and the current printer and network configurations.
FORMAT CARD
A: B: Format Memory Card
Caution • Perform this operation only when it is necessary to erase all
previously stored information from the memory card.
1. When the LCD displays INITIALIZE CARD , press the left oval to select the
A memory (internal CompactFlash) or the right oval to select B memory
(PCMCIA card). (If you are prompted for a password, enter your password
using the instructions in
Password-Protected Parameters on page 43 .)
The front panel LCD asks ARE YOU SURE? .
2. Do you wish to continue?
• Press the left oval to select NO to cancel the request and return to
INITIALIZE CARD prompt.
• Press the right oval to select YES and begin initialization.
FORMATTING CARD displays.
When formatting is complete, INITIALIZE CARD displays.
Note • Depending on the amount of memory in the memory card, initialization may
take up to three minutes to complete.
Table 7 • Standard LCD Displays (Page 5 of 16)
Parameter Action/Explanation