Zebra Technologies R110Xi User Manual
Page 179
Index
23063L-003 Rev. 1 12/6/04
R110Xi/R170Xi User Guide
167
printer settings (continued)
RFID settings, 62
RFID tag type, 63
saving, 42
sensor type, 45
serial communications, 50
setting through front panel, 42
start print signal, 57
time, 59
verifier port, 56
ZPL mode, 53
printer setup checklist, 8
printhead
cleaning, 117
early warning message, 47
head close setting, 54
head resistor value setting, 56
head test count setting, 56
pressure adjustment, 39
when to clean, 116
product improvements, 151
proprietary statement, 151
protocol setting, 51
R
R110Xi
general specifications, 145
label specifications, 148
ribbon specifications, 147
R170Xi
general specifications, 146
label specifications, 148
ribbon specifications, 147
read power
change through front panel, 63
change using ZPL, 93
read RFID tag
read or write RFID format (^RF), 83
read RFID tag (^RT), 91
related documents, xii
relative humidity requirements, 10
remove used ribbon, 31
replace fuse, 122
report shipping damage, 9
reset network option, 61
reship the printer, 9
resynch mode setting, 58
return data to host computer (^HV), 80
RFID
calibrate RFID tag from front panel, 63
calibrate RFID tag using ZPL (^HR), 78
change read power through front panel, 63
change read power using ZPL, 93
change write power through front panel, 63
change write power using ZPL, 93
create label formats, 69
display tag data, 64
enable motion, 85
error status, 63
guidelines, 65
LCD displays, 62
number of retries for block (^RR), 86
power settings, 68
RFID setup command (^RS), 87
RFID tag type, 63
RFID test, 62
“smart” labels, 15
transponder placement, 66
verify write operation (^WV), 97
when to perform calibration, 68
ZPL commands, 77
ribbon
adhesive test, 16
create ribbon leader, 27
determining coated side, 16
load, 26
removal, 31
RIBBON IN
ribbon LED setting, 58
ribbon low warning, 47
Ribbon Out
scratch test, 17
specifications, 147
troubleshooting wrinkles, 131
when to use, 16
Ribbon S. setting, 58
ribbon sensor
calibration procedure, 50
cleaning, 119
location, 119
sensitivity calibration, 36
when to clean, 116
roll media loading, 21
routine maintenance, 115
RS-232 interface connections, 104
RS-422/RS-485 interconnections, 106