ZyXEL Communications 56K Plus Series User Manual
Page 39
Omni 56K Plus Series User’s Guide
Command Sets 4-11
Table 4-9 Supported Commands (per TIA PN2388 8/20/90)
COMMAND DESCRIPTION VALUE
+FDR
Receive phase C data command; initiates document reception.
+FDT=df,vr,wd, ln
Transmit phase C data command: release the DCE to proceed with
negotiation.
+FET=n
End of page or document command:
More pages; same document.
n=0
End of document; another document follows.
n=1
No more pages or documents.
n=2
Procedure interrupt; another page follows.
n=4
Procedure interrupt; end of document, another document follows.
n=5
Procedure interrupt; end of document.
n=6
+FK
Regular fax abort command.
+FLID="string"
Local ID string parameter.
+FLO=n
Flow control options:
No flow control.
n=0
Set XON/XOFF software flow control.
n=1
Set CTS/RTS hardware flow control.
n=2
+FLPL=n
Document for polling command:
The DTE has no document available for polling.
n=0
Indicate a document available for polling.
n=1
+FMDL? Request
DCE
model.
+FMFR? Request
DCE
manufacturer.
+FMINSP=n
Minimum phase C speed parameter:
2400
bps.
n=0
4800
bps.
n=1
7200
bps.
n=2
9600
bps.
n=3
12000
bps.
n=4
14400
bps.
n=5
+FPHCTO=
DTE Phase C response time-out:
Determine how long the DCE will wait for a command after reaching
the end of data when transmitting in Phase C.
0-255
+FPTS=n
Page transfer status
Received page good.
n=1
Page bad; retrain requested.
n=2
Page good; retrain requested.
n=3