ZyXEL Communications 56K Plus Series - Manual (Page 38)

Omni 56K Plus Series User’s Guide
4-10 Command Sets
Table 4-9 Supported Commands (per TIA PN2388 8/20/90)
COMMAND DESCRIPTION VALUE
Only check 1D phase C data. n=1
Check both 1D and 2D phase C data. n=2
+FCR=n "Capability to receive" parameter
DCE will not receive message data or poll a remote device. n=0
DCE receives message data or polls a remote device. n=1
+FDCC=vr,br,wd,ln,d
f,ec,bf,st DCE capabilities parameters.
Vertical resolution: Normal; 98 lpi. vr=0
Vertical resolution: Fine; 196 lpi. vr=1
Bit rate: 2400 bit/s; V.27ter. br=0
Bit rate: 4800 bit/s; V.27ter. br=1
Bit rate: 7200 bit/s; V.29 or V.17. br=2
Bit rate: 9600 bit/s; V.29 or V.17. br=3
Bit rate: 12000 bit/s; V.17. br=4
Bit rate: 14400 bit/s; V.17. br=5
Page width: 1728 pixels in 215mm. wd=0
Page width: 2048 pixels in 255mm. wd=1
Page width: 2432 pixels in 303mm. wd=2
Page length: A4; 297mm. ln=0
Page length: B4; 364mm. ln=1
Page length: unlimited length. ln=2
Data compression format: 1-D; modified Huffman. df=0
Data compression format: 2-D; modified Read. df=1
Error correction disabled. ec=0
Disable binary file transfer. bf=0
Minimum scan time/line: 0 ms. st=0
Minimum scan time/line: 5 ms. st=1
Minimum scan time/line:10 ms (normal); 5 ms (fine). st=2
Minimum scan time/line:10 ms. st=3
Minimum scan time/line:20 ms (normal); 10ms (fine). st=4
Minimum scan time/line:20 ms. st=5
Minimum scan time/line:40 ms (normal); 20ms (fine). st=6
Minimum scan time/line:40 ms. st=7
+FDCS=vr,br,wd,ln,d
f,ec,bf,st Current session parameter; refer to +FDCC command.
+FDIS=vr,br,wd,ln,df,
ec,bf,st Current session negotiation parameter; refer to +FDCC command.