Yamaha RX-V1800 - Manual (Page 123)

119
En
Advanced setup
AD
V
ANCED
OPERA
T
ION
English
Setting remote control TUNER ID
1
Set the operation mode selector to C
AMP or
C SOURCE and then press 1TUNER on the
remote control to select the tuner to change
the remote control ID.
2
Press and hold L
LEARN for about 3
seconds using a ballpoint pen or similar
object until “L;TUN” and “TUNER”
alternately appear in the display window (A).
• Be sure to press and hold LLEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
3
Press 3
ENTER.
The four-digit code set for the selected input area
appears in the display window (A) on the remote
control.
4
Press the numeric buttons (5) to enter the
four-digit remote control code for the input
area you want to use.
*1 The remote control setting.
*2 The setting of this unit.
5
Press 3
ENTER to set the number.
“OK” appears in the display window (A) if the
setting was successful.
“NG” appears in the display window (A) if the
setting was unsuccessful. In this case, start over from
step 2.
6
Press L
LEARN again to exit from the setup
mode.
■ Remote control
XM ID RC XM ID
(U.S.A. and Canada models only)
Use this feature to set the XM ID of this unit for remote
control recognition.
Choices: ID1, ID2
• Select “ID1” when the remote control XM ID library
code is set to “2604”.
• Select “ID2” when the remote control XM ID library
code is set to “2605”.
Setting remote control XM ID
1
Set the operation mode selector to C
AMP or
C SOURCE and then press 1XM on the
remote control to select the XM to change the
remote control ID.
2
Press and hold L
LEARN for about 3
seconds using a ballpoint pen or similar
object until “L;TUN” and “XM” alternately
appear in the display window (A) on the
remote control.
• Be sure to press and hold LLEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
3
Press 3
ENTER.
The four-digit code set for the selected input area
appears in the display window (A) on the remote
control.
Notes
Remote
control
TUNER ID
code *1
Function
RC TUNER
ID *2
2602
(initial setting)
Operates this unit using the
default code. ID1
(initial setting)
2603
Operates this unit using an
alternative code.
ID2
LEARN
3 seconds
Notes
LEARN
LEARN
3 seconds