Xerox MACHINE DATA SHEET G0561 - Manual (Page 12)

Quick Scan to SMB Setup
Xerox WorkCentre
®
Pro 123/128/133
10
Quick Scan to SMB Setup
Files can be scanned on the multifunction device and routed on to a server or a client using SMB protocol.
Directory structures (repositories) need to be created on the server to hold the scanned documents.
See also:
System Administrator Guide: Contains detail concerning Scan to SMB setup.
User Guide: Contains information on how to set up templates and repositories.
Prerequisites for Scan to SMB Setup
1. Confirm that an existing operational network utilizing TCP/IP is available.
2. SMB Server exists and is running.
3. Repository (folder) needs to be created on the SMB server to hold the scanned document.
4. Confirm that the following ports are enabled:
a. TCP/IP Port
b. SMB Port
c. SNMP Port
d. SOAP Port
Data to Set Up Scan to SMB
Install
Requirement
Comments
Server IP address Required This is the IP address of the SMB server.
Server Shared Name Required This is the name assigned to the shared folder on the
SMB server.
Repository -- directory path,
where the document will
be stored on the SMB server Required This is the location or path of the directory for saving
scanned documents.
SMB Login/password
information Optional This is required, if the SMB server requires login/password
authentication. Most SMB servers require a login/password.
Kerberos IP Address Optional If Remote Authentication is required, then Kerberos needs to
be enabled.