Yamaha RDX-E700 - Manual (Page 10)

CONNECTING SPEAKERS
8
1
Remove approximately 10 mm (3/8 in) of
insulation from the end of each speaker
cable and twist the exposed wires of the
cable together to prevent short circuits.
2
Press and hold the lever.
3
Insert one bare wire. By releasing the lever,
the lever is replaced.
■ Notes on the speaker cord
A speaker cord is actually a pair of insulated cables
running side by side. One cable is colored or shaped
differently, perhaps with a stripe, groove or ridge. Connect
the striped (grooved, etc.) cable to the “+” (red) terminals
on the DVD receiver and your speaker. Connect the plain
cable to the “–” (black) terminals on the DVD receiver
and your speaker.
Connect the SUBWOOFER OUT jack on the DVD
receiver to the INPUT jack on the subwoofer
using the subwoofer cable.
• Do not connect the power cable of the DVD receiver or
subwoofer until all cable connections are completed.
• The low frequency range of the downmixed sound is output at
the SUBWOOFER OUT jack.
Connecting speakers
10 mm (3/8 in)
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
Connecting a subwoofer
Notes
SPEAKERS
6 Ω MIN. /SPEAKER
R L
SUB WOOFER
OUT
INPUT
INPUT
Subwoofer
Subwoofer cable