Xerox DOCUCOLOR M123 - Manual

WorkCentre M128/M123 Reference Guide Page 1
dc05cc0364
Xerox DocuColor
Accessing Extended
Features
Overview
This document enables you to access the extended features of the WorkCentre
M128/M123 in environments where Xerox does not provide a custom driver.
NOTE: Some of the commands and syntax used in this documents requires
familiarity with either PostScript (PS) or Printer Command Language (PCL).
This document provides the Printer Description Language (PDL) commands
and syntax for each feature. The following items are also included:
• A PostScript tables that describes the PostScript features the WorkCentre
supports and the syntax to use the feature.
• A PCL table that describes the PCL features the WorkCentre supports and
the syntax to use the feature.
This document is not intended to be a complete PS or PCL reference manual: it
is a guide for using the PS and PCL commands with WorkCentre. Refer to
these additional reference materials: PostScript Language Reference Manual,
Third Edition, ISBN 0-201-38922-8, PCL5 Printer Language Technical
Reference Manual Hewlett-Packard manual and Printer Job Language
Technical Reference Manual, Hewlett-Packard manual.
Using this Guide
1. Search the Feature Table to determine whether the feature you wish to use
is supported.
2. Verify that the feature is supported by the platform. For example, the
WorkCentre must have the Finisher option installed to use stapling
commands.
3. Following across the table to find the syntax listed for the PDL examples
shown. Read the Dependencies/Caveats section.
Xerox WorkCentre
PDL Reference Guide for the
WorkCentre M128/M123
October 20, 2004
dc05cc0364