York 359583-YTG-B-0208 - Manual (Page 2)

359583-YTG-B-0208
2 Johnson Controls Unitary Products
ELECTRICAL/CONTROLS
All units are completely factory wired with all necessary
operating controls. A 24 volt control circuit, with over-
size transformer, is provided for field connection. Units
are designed to operate with conventional thermostat
control interface. The reversing valve solenoid coil
shall be energized in cooling mode only. A manual
reset is provided on each compressor control circuit in
the event of high/low pressure cutout. A time delay
relay for anti-short cycle protection is standard in all
units. An optional condensate overflow switch is avail-
able, complete with an alarm output contact. An
optional remote management package allows the unit
to be controlled by an external source.
FILTERS
All models are shipped with 1 inch thick throw-away fil-
ters factory installed. Filters are accessible from either
side of unit.
PRODUCT NOMENCLATURE
Water Cooled Package Heat Pump and AC Model Number Nomenclature
R P 060 C00 V 2 L AB 1
Product Category
R = Watercooled ID Package,HP
Product Generation
1 = First Generation
Product Identifier
P = HP, R-22 High Efficiency
1 = 208/230-1-60
2 = 208/230-3-60
Nominal Cooling Capacity - MBH
007 = 0.5 Ton
009 = 0.75 Ton
012 = 1 Ton
018 = 1.5 Ton
024 = 2 Ton
030 = 2.5 Ton
036 = 3 Ton
048 = 4 Ton
Heat Type
060 = 5 Ton C00 = No Heat Option
AA = None AG = AB + AE
AB = Insulated Water Circuit(Not available on cooling only) AH = AB + AF
AC = Cooling only (No Reversing Valve) AJ = AC = AD
AD = Cupro Nickle Heat Exchanger AK = AC = AE
AE = Condensate Overflow Switch w/ Alarm output AL = AC = AF
AF = Remote Management Relay Pkg w/ Alarm output
Voltage
4 = 460-3-60
Installation Options
L = Left Hand Return
R = Right Hand Return
Additional Options
8 = 265-1-60
5 = 575-3-60
V = Vertical
H = Horizontal
Airflow