beautypg.com

York B1HH018 User Manual

Champion, Series single package heat pumps, Installation instruction

background image

GENERAL

YORK Model B1HH units are factory assembled heat pumps
designed for outdoor installation on a roof top or a slab. Field-
installed electric heater accessories are available to provide
supplemental electric heat combined with electric cooling and
heating.

The units are completely assembled on rigid, removable
base rails. All piping, refrigerant charge, and electrical wiring
is factory installed and tested. The units require only electric
power and duct connections at the point of installation.

The electric heaters have nickel-chrome resistance wire ele-
ments and utilize single point power connection.

INSPECTION

As soon as a unit is received, it should be inspected for possi-
ble damage during transit. If damage is evident, the extent of
the damage should be noted on the carrier's freight bill. A
separate request for inspection by the carrier's agent should
be made in writing. Refer to Form 50.15-NM for additional in-
formation.

REFERENCE

Additional information on the design, installation, operation
and service of this equipment is available in the following refer-
ence forms:

55.70-N1 — General Installation

55.70-N2 — Pre-start & Post-start Check List

511.26-N1.1V — Electric Heater Accessory

REPLACEMENT PARTS

Refer to Replacement Parts Manual for complete listing of
replacement parts on this equipment.

Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make the
installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury
and/or equipment damage may result if installation procedure is not handled properly.

CAUTION

THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH THE ENCLOSED INSTALLATION INSTRUCTIONS
AND ANY APPLICABLE LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED TO, BUILDING, ELEC-
TRICAL, AND MECHANICAL CODES

WARNING

INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE OPERATION OF THE PRODUCT COULD CAUSE
PERSONAL INJURY, PROPERTY DAMAGE AND/OR DEATH.

WARNING

DE-ENERGIZE THE ELECTRICAL POWER TO THE UNIT BEFORE ATTEMPTING TO INSPECT, REPAIR OR PERFORM
MAINTENANCE TO THE UNIT.

CHAMPION

®

SERIES

SINGLE PACKAGE HEAT PUMPS

Supersedes: 66297-YIM-B-1004

66297-YIM-C-0205

INSTALLATION INSTRUCTION

®

MODELS B1HH018 THRU 060

1.5 THRU 5 TON

(12 SEER)

This manual is related to the following products: