Yamaha DRX-2 - Manual (Page 64)

59 User preferences
Depending on which audio outputs are used, you can select the settings in this menu.
If you only use the analogue audio output (AUDIO L, R), select the settings “Off” in
the “Digital output” menu.
“Digital output”
For devices connected to the DIGITAL AUDIO OUT jack, you can select from the
following settings.
“All”:
Unalterned signals of Dolby Digital and DTS are fed to the digital out-
put. MPEG-2 multi-channel signals are converted to PCM (Pulse Code
Modulation).
For receivers/amplifiers with digital multi-channel sound decod-
ers.
“PCM only”: Dolby Digital and MPEG-2 multi-channel signals are converted to PCM
(Pulse Code Modulation).
For receivers/amplifiers without digital multi-channel sound
decoders.
“Off ”: Digital output switched off.
For devices with analogue audio input.
“Analog output”
For devices connected to the analogue audio output (AUDIO L, R), you can select
from the following settings.
“Stereo”:
For devices without DolbySurround, use this setting if the DVD
recorder is only connected to a stereo TV set.
“Surround”: Dolby Digital and MPEG-2 multi-channel are mixed down to a Dolby
surround-compatible two-channel output signal. For devices with
Dolby Surround Pro Logic decoder.
“Night mode”
Night mode optimises the sound for playback at low volume. You are therefore less
likely to disturb your neighbours. This only works for Dolby Digital audio on DVD
video discs.
Problem
✘ No picture appears on the TV after switching
Check the display of your DVD recorder.
“PRO”: “Progressive Scan” is on
No display: “Interlaced” is on. Switch your TV to the corresponding input jack
or select the corresponding connection. You can also switch the Component
video output signal as follows:
1 Disconnect the recorder’s power cord.
2 Hold down t on the DVD Recorder while reconnecting the power cord.
“PRO” (progressive scan) appears on the display.
3 If you want to switch back, repeat steps 1 and 2. “PRO” disappears from the dis-
play. The DVD Recorder is switched to “Interlaced.”
Sound settings
n
Digital output All
Analog output Stereo
Night mode Off
Sound