ZyXEL Communications 2WG - Manual (Page 38)

ZyWALL 2WG Support Notes
All contents copyright (c) 2006 ZyXEL Communications Corporation.
38
Key Settings:
Class Name Give this class a name, for example, 'App'
Bandwidth
Budget
Configure the speed you would like to allocate to this class
Priority
Enter a number between 0 and 7 to set the priority of this class. The higher the number,
the higher the priority. The default setting is 3.
Bandwidth
Borrowing
Check this box if you would like to let this class to borrow bandwidth from it's parents
when the required bandwidth is higher than the configured amount. Do not check this if
you want to limit the bandwidth of this class at the configured value.(Please note that
you should also disable Maximize Bandwidth Usage on the interface to meat the
condition.)
Enable
Bandwidth
Filter
Check this to specify the traffic types via IP addresses/Port numbers.
Destination IP
Address
Enter the IP address of destination that meats this class.
Destination
Subnet Mask
Enter the destination subnet mask.
Destination
Port
Enter the destination port number of the traffic.