ZyXEL Communications Prestige 2002 Series - Manual (Page 8)

Prestige 2002 Series
8
LED COLOR STATUS DESCRIPTION
On The telephone(s) connected to this port is (are) in use.
Blinking The telephone(s) connected to this port is (are) ringing.
Phone 1-2 Green
Off The telephone(s) connected to this port is (are) not in use.
3 Setting Up Your Computer’s IP Address
For initial configuration, your computer must have an IP address in the
same subnet as 192.168.5.1.
Use this section to assign your computer a static IP address in the 192.168.5.2 to 192.168.5.254
range with a subnet mask of 255.255.255.0. This is necessary to ensure that your computer can
communicate with your Prestige. Record your original IP address settings so you can set your
computer back to them after you finish configuring the Prestige.
Your computer must have an Ethernet card and TCP/IP installed. TCP/IP should already be installed
on computers using Windows NT/2000/XP, Macintosh OS 7 and later operating systems.
3.1 Windows 2000/NT/XP
1. In Windows XP, click start, Control Panel. In Windows 2000/NT, click Start, Settings, Control Panel.
2. In Windows XP, click Network Connections.
In Windows 2000/NT, click Network and Dial-up Connections.
3. Right-click Local Area Connection and then click Properties.
4. Select Internet Protocol (TCP/IP) (under the General tab in Win XP) and click Properties.
VoIPon Solutions www.voipon.co.uk [email protected] Tel: +44 (0) 1245 600560