Xerox DP 820 - Manual (Page 12)

Xerox DP 820 User’s Guide 7
Connecting the Projector
Connecting the Projector
Connecting the Projector to a Computer
In this configuration, the projector displays the images from your
computer’s screen. This is the configuration to use to project a
presentation from your computer.
1. Make sure the projector and computer are turned off.
2. Connect one end of the VGA connector to the VGA port on the
computer.
3. Connect the other end of the VGA cable to the Computer In
port on the back of the projector.
4. Plug the power cord into the projector and then into an
electrical outlet.
5. Turn on the projector first, and then the computer.
6. If you don’t see an image, or if you have multiple video sources
connected to the projector simultaneously, press the Source
button on the projector’s control panel, or remote control, to
switch to the input source.
NOTE: Your DP 820 projector works best when the computer
screen resolution is set to 800 x 600.
VGA Connector
Computer In Connector
VGA Cable