Xerox 8264E EN - Manual (Page 34)

3 Basic Operation
28 8254E / 8264E Quick Start Guide
3.4 8264E Cutting media manually
• When printing is finished, the media guide is hot. Wait until the media guide cools off.
Follow the procedure below to cut roll media.
1. Verify the following regarding the operational condition of the printer:
• Printing or other operations are not in progress.
• "Ready to Print"is displayed on the control panel.
2. If the roll media cut position is changed, refer to 3.1 Feeding media and advance the roll media to
the desired cut position.
3. Open the front cover.
• Pay attention to the following points when you cut roll media. Mishandling the
razor blade may cause a cut on your finger or hand.
• When you hold media, do not place your finger on the media cut groove.
• Move the razor blade along the media cut groove.
No. Name
1 Front cover