Zoom ADSL X4 - Manual (Page 23)

Chapter 1: Installation Instructions 23
3333
Select Enabled from the Current Connection drop-down
list. (That is, click the arrowhead
at the far right of the box
to view the items in the list, then select Enabled.)
4444
Select your service provider’s Encapsulation setting from the
Encapsulation drop-down list. Depending on your selection,
do the following:
! If your Encapsulation setting begins with PPP: Enter
your Username and Password in the boxes provided.
Your Internet service provider should have given you a
User ID or User Name (usually your email address or the
characters preceding the @ sign in your email address) and
a Password. (These are NOT the same User Name and
Password you that you used earlier to open the Zoom
Configuration Manager.)
Tip:
If you do not know your Username and Password,
contact your service provider and tell them that you
misplaced the information.
! If your Encapsulation setting begins with 1483
Bridged or 1483 Routed: The Username and Password
boxes will automatically disappear from the page because
you do not need to enter this information. Continue with
step 5.
Important!
If you plan to use a static IP address, you must manually
configure the X4 from the WAN Configuration page and
not the Basic Setup page. For more information, see
Using Static IP Addressing on page 25. Typically, you
must make arrangements with (and pay) your Internet
service provider for a static IP address.
5555
In the VPI and VCI boxes, enter the settings for your service
provider.