Removing the oven door, Aring for your oven – Whirlpool KEBS247D User Manual
Page 45
45
Removing the oven door
For normal use of your oven, you do not
need to remove the door. However, you can
remove the door by following the instructions
in this section.
The oven door is heavy. Use both hands
to remove and replace the door. Do not lift
and carry the door by the handle. To remove
and replace the door you may need help.
To remove:
1.
Open door all the way.
NOTE:
Two
5
⁄
32
" Allen wrenches or two nails
of similar diameter may be used if factory
furnished door removal pins have been
misplaced. Be careful not to damage
porcelain finish.
2.
Insert small end of a door removal pin
into each door hinge.
3.
Grasp under handle and gently close
door as far as it will shut. Pull door out
at bottom to remove.
4.
Set door aside on protected surface.
C
aring for Your Oven
Insert small end
of pin here
To replace:
1.
Fit hinge arms into slots in frame. Push in
at lower corners to insure that hinge arms
are fully engaged.
2.
Open the door all the way.
3.
Remove the door removal pins from
each hole.
4.
Close the door.
NOTE:
If the door does not operate freely,
you have not installed it properly. Repeat
Steps 1-4.