Warning, Unpack the air conditioner, Prepare air conditioner for installation – Whirlpool 66161279 User Manual
Page 6
6
2. Press RESET (on some devices, a green light will turn on).
3. Press TEST (listen for click; Reset button will trip, and on
some devices, a green light will turn off).
4. Press and release RESET (listen for click; Reset button will
latch, and on some devices, a green light will turn on). The
power supply cord is ready for operation.
NOTES:
■
The Reset button must be pushed in for proper operation.
■
The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
■
Do not use the power supply cord as an off/on switch. The
power supply cord is designed as a protective device.
■
A damaged power supply cord must be replaced with a new
power supply cord obtained from the product manufacturer
and must not be repaired.
■
The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.
INSTALLATION INSTRUCTIONS—5500 BTU, 6300 BTU, 8000 BTU
Unpack the Air Conditioner
Remove Packaging Materials
■
Handle the air conditioner gently while unpacking the unit.
■
Cut the 4 plastic bands that secure the carton.
■
Remove the carton top and lift the air conditioner from the
base pad.
■
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
■
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
■
Remove any packaging materials inserted into the side
louvers.
■
Dispose of/recycle packaging materials.
Prepare Air Conditioner for Installation
Install Top Channel
1. Remove the plastic covering the adhesive on the top channel
seal and attach the seal to the top channel, lining up the holes
in the seal and the top channel.
2. Place the top channel on the top of the air conditioner, lining
up the holes in the top channel with the holes in the top of the
air conditioner.
3. Using four
³⁄₈" screws, attach the top channel to the air
conditioner.
NOTE: Your model may differ from the one shown.
Install Side Curtains
NOTE: Attach curtains to the air conditioner before placing the air
conditioner in window.
1. Place the tabbed side of the side curtain in the track on the
right-hand side of the air conditioner cabinet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
A.
³⁄₈" screws
B. Top channel
A. Tabbed side of side curtain
B. Curtain frame
A
B
A
B