Whirlpool 66161279 - Manual (Page 16)

16
Storing the Remote Control
Store the remote control by placing the back side, containing a
magnet, against the side of the air conditioner cabinet in the
locations shown in the following illustration.
NOTE: The dotted lines do not appear on the unit cabinet. They
show the locations of the metal plates in the illustration only.
Power
1. Press POWER to turn on air conditioner.
2. Press POWER again to turn off the air conditioner.
Mode
Press MODE to choose Cool, Eco (on some models), Overnight
(on some models) or Fan Only.
Fan Speed
1. Press FAN SPEED until you see the Bar LED on the air
conditioner control panel display for the desired setting.
2. Choose Low, Medium, High or Auto.
NOTES:
■ Auto fan speed and Temperature cannot be selected in
Fan Only mode.
■ In Eco (on some models) and Cool modes, Auto fan
speed is selected automatically.
NOTE: After 5 seconds, the display on the air conditioner control
panel will show the current room temperature.
Temperature
■ Press the up arrow button to raise the temperature. Each time
you press or hold the up arrow button, the temperature will go
up 1ºF (1ºC) until it reaches 86°F (30°C).
■ Press the down arrow button to lower the temperature. Each
time you press or hold the down arrow button, the
temperature will go down 1ºF (1ºC) until it reaches 61°F
(16°C).
Changing Air Direction
Use tab to direct the air right or left.
AIR CONDITIONER CARE
Your new air conditioner is designed to give you many years of
dependable service. This section tells you how to clean and care
for your air conditioner properly. Call your local authorized dealer
for an annual checkup. Remember … the cost of this service call
is your responsibility.
Cleaning the Air Filter
The air filter is removable for easy cleaning. A clean filter helps
remove dust, lint, and other particles from the air and is important
for best cooling and operating efficiency. Check the filter every
2 weeks to see whether it needs cleaning.
NOTE: Do not operate the air conditioner without the filter in
place.
1. Turn off the air conditioner.
2. Remove the air filter by pressing down on the tabs on the air
intake grille and pulling the grille away from the air
conditioner.
Power
Mode
Fan Speed
A. Tab
V
V
A