beautypg.com

Ch 4 - setup, Chapter 4, Entering the set up menu – Watlow Electric Micro-Based Autotuning Control SERIES 980/985 User Manual

Page 24: The set up menu, Chapter, How to setup the series, Entering the setup menu

background image

Chapter

4

NOTE:

While in the Setup

menu, all outputs

are OFF.

Figure 27 -
Entering the Setup
Menu.

Figure 28 -

The Setup Menu.

NOTE:

When using a

process input such

as O-5VDC or
4-2OmA, the rL and

rH settings scale the

display to match the

measured range of

the process signal.

How To Setup The Series

9801985

Setting up the Series 980/985 is a simple process. First configure the 980/
985’s features to your application in the Setup Menu, and then enter values in

the

Operating

Menu. Both tasks use the MODE key to move through the

menus and the UP/DOWN keys to select data.

Entering the Setup Menu

The Setup Menu displays the parameters that configure the Series 980/985’s

features to your application.

To enter the Setup Menu, press the UP and DOWN keys simultaneously for 3

seconds. See Figure

27.

The Lower display shows the LOC parameter, and

the Upper display shows its current level. All keys are inactive until you release

both keys. You can get to the LOC parameter from anywhere.

Use the MODE key to cycle through the menu; use the UP/DOWN keys to

select Setup data. You may not see all the parameters in this menu, depend-

ing on the unit’s configuration and model number. After stepping through the

menu, you will return to the control set point parameter under the Operation

menu.

Mode Key

Prompt appears or not according
to control configuration.

Control Set Point

24

WATLOW

Series 980/985 User’s Manual

Setup, Chapter 4