Watlow Electric Micro-Based Autotuning Control SERIES 980/985 - Manual (Page 17)

Output 1 Option “D”, 6 Amp Mechanical Relay
Model#98_A-_D _0-0000
Mechanical
Relay
Mechanical Relay
The Electromechanical relay iS an electrical and mechanical with moving parts.
When power is applied to the relay solenoid, Contact closure is Created through move-
ment of the “Common” Contact of the relay.
Off state impedance is 2 O K o h m minimum.
Output 1 Option “E”, 0-I0 VDC
Model# 98_A-_E _0-0000
Process Output,
Proportional value determined by the Control to balance the sensor input and set point.
This value will fall between 0-10VDC depending on your process output type.
Figure 16 -
6 Amp mechanical
Relay, Output 1,
Optlon “D” Wlrlng
Diagram.
Figure 17 -
0-10VDC, Output 1,
Optlon "E" Wiring
Diagram.
Install and Wire, Chapter 2
WATLOW Series 980/985 User’s Manual 17