Wintal PVR10 - Manual (Page 41)

41
10. SettIngS
To enter the settings screen, select MEnu 
SEttINGS
and press the key.
10.1 general SettIngS
Use the and keys to select
the setting you would like to change. Pressing
will bring up the options available for your
selection.
EXIT to save your changes.
note: Bold items
are the default values.
ASPECt RAtIo
: The aspect ratio depends how the picture fits on your TV.
Options are:
1. Pan and Scan 4:3
2. Letterbox 4:3
3. Default 4:3
4. Pan & Scan 16:9 5. Letterbox 16:9
6.
default 16:9
RESoLUtIoN
:
1. 576p
2. 720p 50Hz 3. 720p 60Hz
4.
1080i 50hz
5. 1080i 60Hz
6. 1080p 50Hz 7. 1080p 60Hz
note:
Ensure that you select the correct resolution for your TV. Refer to your TV’s manual if in doubt. Should you choose a wrong resolution
and the screen goes black, wait for 10 seconds without pressing any buttons and your PVR10HD will revert to the previous working resolution.
tIME ZoNE SEt
:
1. vIc
2. NSW/ ACT
3. QLD
4. SA 5.WA
6. TAS 7. NT
CLoSEd CAPtIoN
: Closed captions are available only if it is being streamed by the broadcaster.
See section 3.7 “Closed Captions” on page 20 for more information.
1. On
2. off
dAYLIGht SAVING tIME
: Set it to on if you are observing DST.
1. On 2. off
MENU tRANSPARENCY
: Set the opacity for the on-screen menu,
1. High 2. Middle 3. Low 4. default
AUdIo dECodE
: Sets the audio output via the rear S/PDIF port. If your AV receiver can decode Dolby Digital
signals set it to “Dolby Digital”. If not, set it to “PCM” to output the decoded signal.
1.
dolby digital 2. PCM
note:
Dolby Digital surround sound is only available if it is streamed by the broadcaster.
PIP
: Enable or disable Picture-in-Picture. For more information on PIP, please refer to section 3.8 Picture-in-
Picture (PIP) on page 20.
1. On
2. off