Wintal PVR10 - Manual (Page 17)

17
2.3 Power on
Once you have completed all required connections, you may power on your PVR10HD.
▪ Connect one end of the power supply to the 12V 3A input on the PVR10HD
▪ Connect the other end of the power supply to the wall outlet
▪ Turn on your TV and switch it to the mode you have connected your PVR10HD to (ie. HDMI)
▪ Turn on your PVR10HD and wait for the system to initialise.
note:
Make sure the PVR10HD is switched on at the back.
2.4 Search channel
Once system initialization is complete, you should perform a channel search, if there is no channel stored in the
receiver. For more information on searching, please refer to section 8. “Channel Search” on page 37.
If there are pre-stored channels on your PVR10HD it will be displayed automatically with the channel number and
if available, channel name displayed on the front panel.
3. BaSIc oPeratIon
This section explains the basic operation and various features of your PVR10HD.
3.1 SwItchIng channelS
There are a number of ways to switch channels:
▪ channel up and channel down
Using the channel up and channel down buttons on
the PVR10HD remote
▪ numeric keypad
Directly entering the channel number on the remote using the number keys
▪ channel list
Selecting a channel via the Channel list (press the OK button
on your remote)
See section 3.4 for more information.
▪ favourites list
Select a channel via the Favourite Channels list.
If you have pre-selected favourite channels, press the FAV key and press OK after having made a selection
with the
and keys.
See section 3.4 for more information on how to set up favourite channels.
3.2 voluMe control
Press the volume down or volume up keys to change the volume.