Westell Technologies Versalink 327W - Manual (Page 92)

030-300500 Rev. A 92 October 2006
User Guide VersaLink™ Gateway (Model 327W)
12.6.3 Editing the WAN Configuration
The following VC 1 Configuration screen will be displayed if you click on the edit button adjacent to any of the
‘Enabled’ protocols displayed in the WAN Configuration screen. (NOTE: The Protocol must be enabled before
you can edit its VC configuration.) The VC 1 Configuration screen allows you to edit your virtual connection
(VC). A virtual connection identifies a connection through the service provider’s ATM network to your ISP. Unlike
physical hardware connections, virtual connections are defined by data.
If you change any of the VC settings in the following screen, click on the Set VC button.
NOTE: If you experience any problems, please reset VersaLink via the external hardware reset button or via the
procedure defined under the Maintenance menu in section 14.1. The actual information displayed in this screen
may vary, depending on network connection established.