Hardware features, 1 led indicators – Westell Technologies Versalink 327W User Manual
Page 9

030-300500 Rev. A
9
October 2006
User Guide
VersaLink™ Gateway (Model 327W)
5. HARDWARE FEATURES
5.1 LED Indicators
 
This section explains the LED States and Descriptions. LED indicators are used to verify the unit’s operation and 
status. 
LED States and Descriptions
LED State
Description
Solid Green
Modem power is ON.
OFF
Modem power is OFF.
POWER
Solid Red
POST (Power On Self Test), Failure (not bootable) or Device 
Malfunction. NOTE: The Power LED should be red no longer 
than two seconds after the power on self test passes. 
Solid Green
Powered device is connected to the associated port (includes 
devices with wake-on LAN capability where slight voltage is 
supplied to an Ethernet connection). 
NOTE: When using the optional uplink port (E1), Ethernet LAN 
connection is limited to E2, E3, and E4. 
Flashing Green
10/100 Base-T LAN activity is present (traffic in either direction)
ETHERNET
(E1, E2, E3, E4)
OFF
Modem power is OFF, no cable or no powered device is 
connected to the associated port. 
Solid Green
Link Established.
Flashing Green
Wireless LAN activity is present (traffic in either direction).
WIRELESS
OFF
Modem power is OFF or No Link.
Solid Green
Good DSL sync.
Flashing Green
DSL attempting to sync.
DSL
OFF
Modem power is OFF.
Solid Green
Internet link established.
Flashing Green
IP connection established and IP Traffic is passing through 
device (in either direction). 
NOTE: If the IP or PPP session is dropped due to an idle timeout, 
the light will remain solid green, if an ADSL connection is still 
present. 
If the session is dropped for any other reason, the light is turned 
OFF. The light will turn red when it attempts to reconnect and 
DHCP or PPP fails). 
Solid Red
Device attempted to become IP connected and failed (no DHCP 
response, no PPP response, PPP authentication failed, no IP 
address from IPCP, etc.). 
INTERNET
OFF
Modem power is OFF, Modem is in Bridge Mode, or the 
connection is not present. 
NOTE: Safe Boot is reflected when the Power and Internet LEDs are both Red and all other LEDs are off.
 
 
 
 
 
 
 
 
