VIEWSONIC PJ650/PJ520 - Manual (Page 30)

Input Menu
With the INPUT menu, the four items shown in the Table below can be
performed. With inputting of RGB IN 1 and RGB IN 2 signals, the horizontal
and vertical frequencies of the signals will be displayed on the initial screen of
the INPUT menu.
Perform each operation in accordance with the instructions in the Table.
Item Description
AUTO Auto Adjust (for RGB): Automatically adjusts H POSITION, V POSITION, H PHASE, and H SIZE.
Use this function with the maximum window size.
Auto Adjust (for VIDEO/S-VIDEO): Automatically selects the proper VIDEO mode for the current
input signal. This function is active only when the AUTO mode is selected for the item VIDEO. Refer
to the description for the item VIDEO below.
This function may not be available with a PAL60 signal and certain other signals.
The AUTO mode operation requires approximately 10 seconds.
For COMPONENT VIDEO, the signal type is identified automatically even if this function is inactive.
For a HDTV signal, refer to the item HDTV below.
VIDEO Select Mode of Signal Type (for VIDEO/S-VIDEO):
AUTO NTSC PAL SECAM
NTSC4.43 M-PAL N-PAL
Selecting AUTO mode activates and performs the AUTO function for VIDEO/SVIDEO. It
automatically selects the proper mode from among those above. Use this function if the image
becomes unstable with VIDEO/S-VIDEO. (e.g. The image becomes irregular, or lacks color.)
•
AUTO mode may not function correctly with a PAL60 signal and certain other signals.
• The AUTO mode operation requires approximately 10 seconds.
• For COMPONENT VIDEO, the signal type is identified automatically even if this func- tion is
inactive. For a HDTV signal, refer to the item HDTV below.
HDTV Select HDTV Signal Mode:
1080i
1035i
• If the selected HDTV mode is incompatible with the input signal, the picture may be distorted.
SYNC ON G On/Off SYNC ON G Mode:
TURN ON TURN OFF
Selecting TURN ON turns on the SYNC ON G mode. The SYNC ON G mode allows reception of
SYNC on G.
•
In the SYNC ON G mode, the picture may be distorted with certain input signals. In such cases,
remove the signal connector so that no signal is received and turn SYNC ON G off, and then
reconnect the signal.
ViewSonic PJ650/PJ520 27