VTech LS6126-3 - Manual (Page 40)

www.vtechphones.com 37
B
as
ic
o
pe
ra
tio
n
Answering system
A
ns
w
er
in
g s
ys
te
m
If you have caller
ID servce, the
clock wll be set
automatcally wth
ncomng calls,
but you wll need
to make sure the
year s correct.
See Set the clock
for nstructons
on how to set the
year, tme and day
manually.
Press and hold
/ SKIP or
/ REPEAT whle
settng the mnutes
or year to advance
or decrease by
ncrements of ten.
•
•
Set the clock
Pror to playng a message, the answerng system announces when t was
receved. Before usng the answerng system, set the year, tme and day, so that
messages are dated correctly. If the clock s not set before new messages are
recorded, the system wll announce “Time and day not set,” before each message
s played to remnd you to set the clock.
Press CLOCK. The system announces the clock settng (e.g. year, tme and
day), then announces: “To set the clock, press CLOCK.”
Press CLOCK. The system announces the current year.
Press /SKIP or /REPEAT untl the system announces the correct year, then
press CLOCK. The system announces the current hour.
Press /SKIP or /REPEAT untl the system announces the correct hour, then
press CLOCK. The system announces the current mnute.
Press /SKIP or /REPEAT untl the system announces the correct mnute,
then press CLOCK. The system announces the current day.
Press /SKIP or /REPEAT untl the system announces the correct day, then
press CLOCK. After a confirmation tone, the system announces the new clock
settng and exts programmng mode.
1.
2.
3.
4.
5.
6.