Vidikron Vision 50 User Manual
Vidikron Projectors
Table of contents
Document Outline
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1 Introduction
- 2 Controls and Functions
- 3 Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens Mount
- 3.5 Mounting the Vision 50
- 3.6 Connections to the Vision 50
- 3.7 Turning on the Power
- 3.8 Changing the OSD Language
- 3.9 Adjusting the Picture Orientation
- 3.10 Primary Lens Adjustments
- 3.11 Installing and Adjusting the CineWide Anamorphic Lens
- Anamorphic Lens Installation and Adjustment - Vision 50/CineWide
- Anamorphic Lens Installation and Adjustment - Vision 50/CineWide with AutoScope
- 4 Operation
- 4.1 Selecting Video Memory
- 4.2 Selecting an Aspect Ratio
- 4.3 Selecting An Input Source
- 4.4 Using Picture-In-Picture/ Picture-By-Picture (PIP/PBP)
- 4.5 Using the On-Screen Menus
- Figure 4-1 . Vision 50 OSD Menu Structure
- Main Menu
- Picture Adjust
- Image Option
- Projector Status
- Installation
- Service
- White Balance
- Gamma Selection
- ICC Adjust
- Image Over Scan
- Video Black Level
- Aperture Control
- Image Shift
- Amplitude
- Horizontal Masking (Vision 50/CineWide and Vision 50/CineWide with AutoScope only)
- Fan Control
- Lamp Reset Timer
- RS-232 Baud Rate
- Remote Control
- Screen Trigger Mode (Vision 50/CineWide with AutoScope only)
- Return to User OSD
- ISF Calibration
- 5 Maintenance and Troubleshooting
- 6 Serial Communications
- 7 Specifications
- Appendix A. Personalizing the ISF Splash Screen on the Vision 50