Vista Ademco N7227V5 - Manual (Page 29)

Section 7 - 4285/4286 VIP Module
7-3
4285/4286 VIP Module WIRING NOTES:
1. Wire the VIP Module exactly as shown, using a direct-connect cord and RJ31X jack.
2. If you do no hear tones when pressing keys after accessing the security system via an on-premises
phone, try reversing the pair of wires connected to terminals 3 and 4 on the VIP Module and the
pair of wires connected to terminals 17 and 18 on the control.
3. If you hear an error signal (fast busy signal) when trying to access the system via the phone, check
for correct line seizure wiring, as described in note 4.
4. Connection to the incoming telco line via a RJ31X jack and direct-connect cord, as shown in this
diagram, is essential, even if the system is not connected to a central station. The 4285 or 4286
will not function if this is not done.
The house phone lines (gray and brown wires) must be wired to the VIP Module
terminals, not to the control terminals. Otherwise, an error signal (fast busy signal) will
occur when you try to access the system from an on-premises phone.
5. If the telephone system on the premises includes a Caller ID unit, connect the unit directly to the
“Handset” terminals (17 and 18) on the control, as shown.
18
ANSWERING
MACHINE
TERMINALS
ON CONTROL TO EARTH GROUND (COLD WATER PIPE, ETC.)
SPEAKER VOLUME
ADJUSTABLE ON
4286 ONLY
UNUSED
KEYED
HEADER
4285/4286
V IP MODULE
1
2345
6
7
YELLOW: TO DATA OUT (term. 7)
NO CONNECTION
RED:
TO AUX (+) (term. 5)
BLACK: TO AUX. GROUND (–) (term.4)
GREEN: TO DATA IN (term. 6)
CONNECTOR
WITH FLYING
LEADS
TO CONTROL
PANEL
TERMINALS
USED FOR
KEYPAD
CONNECTIONS
PREMISES ANSWERING
MACHINE AND PHONES
Handset
Incoming
Teleco Line
TIP RING
RJ31X
JACK
PLUG
DIRECT
CONNECT
CORD TIP
RING
GROUND
MUST CONNECT TO ON 4285
(TIP)
MUST CONNECT TO
ON 4285
(RING)
GREEN (TIP)
RED (RING)
1 2
INCOMING TELCO LINE
NO
CONNECTION
GREY (R) BROWN (T)
4285/4286
TERMINAL ASSIGNMENTS
1 - TIP
2 - RING
PHONE INPUT
3 - TIP
4 - RING
PHONE OUTPUT
5 - NO CONNECTION
6 -
7 -
AUDIO OUT
4286 ONLY
}
}
}
{ {
IMPORTANT NOTE FOR
EXISTING INSTALLATIONS:
EXISTING WIRES
CONNECTED TO THE
"HANDSET" TERMINALS ON
CONTROL MUST BE MOVED
FROM THERE TO TERMINALS
3 AND 4 ON THE 4285.
17 19 20
CALLER ID
UNIT
*
*
* NOTE: IF THE TELEPHONE HAS BUILT-IN CALLER ID,
THE CALLER ID FUNCTION MAY NOT WORK .
21
CA38A
IN
CANADA
V10SE-029-V0
Figure 11. 4285/4286 VIP Module Wiring Connections