VIEWSONIC WPG-360 - Manual (Page 20)

ViewSonic WPG-360 13
2-3-2 Windows Vista / 7 IP address setup:
Click ‘Start’ from windows toolbar locate at bottom
to select control panel. Click View Network Status
and Tasks, then click Manage Network
Connections. Right-click Local Area Netwrok, then
select ‘Properties’. Local Area Connection
Properties window will appear, select ‘Internet
Protocol Version 4 (TCP / Ipv4), and then click
‘Properties’
Select ‘Use the following IP address’, then input
the following settings in respective field:
IP address: 192.168.0.x (where x is an integer
greater or less than 200, if there’s more than one
computer need to use this WPG on the same
network, every computer should use an unique
number)
Subnet Mask: 255.255.255.0
Click ‘OK’ when finish.