Universal Remote Control (URS) URC-SR3 - Manual (Page 8)

Page 8
I
F
Q
UICK
S
ET
-U
P DID NOT WORK
,
TRY THIS
NEXT
:
Three-Digit Code Set-Up Method
STEP 1: Find the 3-digit code numbers assigned to
your brand from the lists in the back of this manual.
The codes are listed by component category (i.e.,
CBL/SAT, TV, DVD/DVR, etc.), then by brand
name. For instance, if you would like to locate a
code for a Sony television, first locate the TV
category and then look for the Sony brand.
STEP 2: Once you have located the 3-digit codes
for each of the components that you wish to
operate with your URC-SR3, write them ALL down
on a piece of paper. It’s important that you write
down all the codes listed for your brand because
only one code is going to work with your
component.
STEP 3: Manually or using your old remote, turn
on the component you want to program—for
example, to program your TV turn on your TV set.
STEP 4: On the URC-SR3, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component LED light turns on.
This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds,the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
COMPONENT
BUTTONS
SELECT
BUTTON