Universal Remote Control (URS) URC-SR3 - Manual (Page 16)

Page 16
Programming “My Button” Custom
Programmable Button
Automatically turn on TV to your favorite channel!
Always begin watching TV on the channel you like
best - you can preset this button with a few simple
steps.
In cable mode, My BUTTON will automatically turn
on TV to your favorite channel. Here’s how to
program this feature:
STEP 1: Press the CBL button to select the Cable
mode.
STEP 2: Press the My BUTTON and the
SELECT[SEL] button at the same time for 2 seconds
until the CBL component LED turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 3: Using the Number Pad, punch in the
Channel number of the channel that you want to
store on the My BUTTON. The Cable component
LED light will blink once for each button pressed.
STEP 4: Press the CHANNEL UP button to store
the commands entered. The CBL component LED
will blink three times to confirm the programming.
SELECT
BUTTON
CH
MY
BUTTON