Universal Remote Control (URS) URC-SR3 - Manual (Page 22)

Page 22
Transport Control “Punch Through”
This “Punch Through” enables you to program the
URC-SR3 so that DVD/DVR/VCR Transport
Controls (PLAY, STOP, FF, REW, PAUSE, SKIP and
RECORD) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component button you
want to add Transport Control to, such as CBL or
TV, and the SELECT [SEL] button at the same time
for two seconds until the Component LED light turns
on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the PLAY button. The component LED
light will blink once.
STEP 3: Press either the DVD button that you want
to use as the source of Transport Control. The
component LED will blink two times to confirm it is
saved.
SELECT
PLAY
COMPONENT
BUTTONS